Dryer shows E13, often on heat pump Vedette dryers, unit may stop and not restart until cooled
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Possible Causes
How to Fix / Troubleshooting
Safety first: Unplug the dryer. Heat pump components can be hot; allow cooling before inspection.
Step-by-step checks:
- Clean condenser: Access the condenser (front lower flap or internal on some models). Remove lint and dust from fins using a soft brush and vacuum. Do not bend fins.
- Check condenser fan: Remove side or rear panel to view the fan near the heat pump. Ensure it spins freely and runs during operation. Replace the fan motor if seized or not running.
- Ventilation: Ensure the dryer has adequate space around it for air circulation and is not installed in a confined, overheated area.
- Observe operation: After cleaning, run a cycle and monitor if E13 recurs. If the compressor cycles off quickly or unusual noises are heard, there may be a sealed system issue.
Important: Refrigerant and sealed system repairs must be performed by a certified refrigeration technician. Do not attempt to open the sealed system yourself.
Repair Difficulty
Required Part
We may earn a commission from links on this page.