E15
Vedette Control Panel Communication / EEPROM Error

Dryer shows E15, beeps, and does not respond to program selection

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Corrupted memory on control board, Faulty communication between UI and main PCB, Power surge damage, Loose harness connectors

How to Fix / Troubleshooting

Safety first: Disconnect the dryer from mains before opening the control area.

Step-by-step checks:

  • Hard reset: Unplug the dryer for 10–15 minutes, then reconnect. Sometimes this clears minor EEPROM or communication glitches.
  • Check connectors: Remove the top cover and inspect all connectors between the user interface and main control board. Reseat them firmly.
  • Inspect for damage: Look for burn marks or corrosion on the boards. If present, replacement is required.

Recommendation: E15 typically indicates a control board fault that is not field-repairable. Replacement of the main control board and/or UI board by a professional is advised.

Advertisements

Repair Difficulty

Professional Required 5/5

Required Part

Main Control Board
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements