E61
Zanussi
Insufficient Heating / Low Temperature Fault
Zanussi dryer heats very slowly or not at all and shows E61.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Partially failed heating element, Faulty NTC temperature sensor, Poor airflow due to blocked condenser, Faulty relay on control board
How to Fix / Troubleshooting
Safety first: Disconnect from mains and allow the dryer to cool before working near the heater or heat pump.
- 1. Clean airflow path: Remove and clean all lint filters. If your model has a removable condenser, rinse it thoroughly. Vacuum dust from air channels and vents.
- 2. Check load size: Overloading can cause poor drying performance. Test with a half-load on a standard program.
- 3. Test NTC sensor: Locate the NTC on the heater housing or air duct. Disconnect and measure resistance; compare with Zanussi specifications (resistance should change with temperature). Replace if readings are out of range.
- 4. Inspect heater: Check for signs of partial burning or hotspots on the heater coil. Test continuity; some elements have multiple circuits—one may be open.
- 5. Control board relay: If the heater and NTC are good, the heater relay on the PCB may not be switching correctly. This typically requires PCB replacement by a technician.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
NTC Temperature Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements