Zanussi dryer display shows very short remaining time and ends the cycle quickly with clothes still wet, no error code.

Safety first: Unplug the dryer before cleaning sensor contacts or accessing wiring.

• 1. Clean moisture sensors: Locate the metal sensor bars inside the drum and clean them with a cloth and white vinegar to remove any insulating residue.
• 2. Adjust load size: Very small loads may not make good contact with the sensors. Add a few similar items or use a timed program for very small loads.
• 3. Check sensor wiring: Access the area behind the front panel to inspect the sensor harness. Ensure connectors are secure and wires are intact.
• 4. Test timed cycle: Run a timed drying program. If drying is normal, the issue is likely with the auto-sensing system, which may need professional calibration or sensor replacement.