Yellow LED Solid
Easee Limited Operation / Configuration or Firmware Issue

Easee charger LED strip is solid yellow and charging is not possible.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Incomplete initial setup, Firmware update in progress or failed, Configuration mismatch with load management system, Internal memory error

How to Fix / Troubleshooting

Warning: Do not interrupt power during a firmware update unless instructed by the manufacturer.

  • 1. Wait a few minutes: If the yellow LED appeared suddenly, wait 5–10 minutes to see if it clears, as the charger may be updating firmware.
  • 2. Check the Easee app: Look for any notification about firmware updates or configuration errors. If prompted, complete the setup wizard.
  • 3. Reboot the charger: Turn OFF the upstream breaker for 30–60 seconds, then turn it back ON. After reboot, check if the LED returns to normal (blue/green).
  • 4. Verify configuration: In the app or installer portal, confirm that supply type (single/three-phase), max current, and load balancing settings match the physical installation.
  • 5. Factory reset (installer only): If configuration appears corrupted and you have installer access, perform a factory reset and re-commission the charger following the Easee installation guide.
Advertisements

Repair Difficulty

Medium 3/5
Advertisements