E11
Land Rover
Configuration / Parameter Fault
Charger shows E11 and refuses to start; app may indicate a configuration or parameter error.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted configuration in Land Rover charger memory, Incorrect region or grid settings, Invalid maximum current or phase configuration, Failed non-volatile memory on control board
How to Fix / Troubleshooting
Safety warning: Do not change advanced electrical settings unless you understand the installation requirements.
- 1. Check app settings: Open the Land Rover charger app and review installation parameters (supply type, max current, load management). Correct any obviously incorrect values.
- 2. Restore factory defaults: Using the app or internal reset button (refer to manual), perform a factory reset of the charger configuration. Reconfigure according to the installation certificate.
- 3. Verify phase configuration: Ensure the charger is set for single-phase or three-phase operation as actually wired.
- 4. Power-cycle after reset: Turn off the breaker for 2–3 minutes after applying new settings, then restore power and test.
- 5. If E11 persists after correct configuration: The non-volatile memory or control board may be defective. Board replacement will likely be required by a service technician.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Land Rover Charger Control Board (Configuration Memory)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements