Charger displays E006; LED ring flashes red rapidly; unit reports overtemperature and stops charging.

Safety first: Components may be hot. Allow the unit to cool before opening.

• Check installation location: Ensure the NewMotion charger is not installed in direct sunlight or near heat sources. Maintain the manufacturer’s recommended clearance around the unit for airflow.
• Inspect vents: Clean any dust, cobwebs, or debris from ventilation slots on the housing. Do not block vents with covers or insulation.
• Check cable glands: Verify that cable glands are tight but not over-tightened to the point of deforming the enclosure and restricting airflow.
• Internal inspection: After isolating power, open the unit and inspect the power module, contactor, and terminal block for signs of overheating (discoloration, melted insulation).
• Tighten power connections: Loose terminals can cause localized heating. Retorque all high-current connections to the manufacturer’s specified torque.
• Sensor verification: Locate the internal NTC temperature sensor on the main PCB or heat sink. If it is detached or damaged, reattach or replace the PCB/module.
• Test after cooldown: Once cooled and reassembled, restore power and monitor temperature readings via the NewMotion app if available. If E006 recurs quickly, a failing sensor or module is likely.