E19
Zencar
Internal Energy Meter Fault
Charger shows E19; display may indicate 'meter error' on models with internal kWh metering.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed internal kWh meter module, Loose meter board connector, Corrupted calibration data, Faulty pulse output to main board
How to Fix / Troubleshooting
Safety first: Turn off power before accessing internal meter boards.
- Power-cycle: Turn OFF the breaker for 2 minutes, then ON, and see if E19 clears.
- Inspect meter board: Locate the internal energy meter PCB (often a small board near the main power path). Ensure its connectors are firmly seated.
- Check for visible damage: Look for burn marks or cracked components on the meter board.
- Firmware/calibration: If Zencar provides a calibration or reset procedure for the meter, follow it carefully.
- Persistent E19: Replace the internal kWh meter module or main control PCB as recommended by Zencar.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Internal kWh Meter Module
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements