AL10
Ignis
Super-Freeze Circuit / Relay Fault
Display shows AL10; freezer may continue to run but super-freeze or fast-freeze function does not work correctly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Defective super-freeze button or switch, Faulty relay on control board, Wiring fault to compressor or fan, Control board logic error
How to Fix / Troubleshooting
Safety first: Unplug the freezer before accessing the control panel or main PCB.
- Check user settings: Confirm that the super-freeze function is being activated correctly according to the Ignis manual (press and hold the correct key).
- Inspect super-freeze button: Remove the control panel and test the button or touchpad for proper operation. Replace the user interface board if the switch is physically damaged or unresponsive.
- Check control board relay: On the main PCB, locate the relay controlling the compressor/super-freeze mode. Look for burn marks or cracked solder joints. Resolder if necessary or replace the board.
If AL10 persists and the freezer otherwise cools normally, the issue is likely within the control electronics and should be handled by a technician.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
User Interface / Display Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements