Cardale
Incorrect Travel Limits or Partially Learned Cycle
Door opens or closes only a short distance (about 30–50 cm) then stops without code.
Advertisements
Possible Causes
Interrupted setup/commissioning procedure, Accidental change of limit settings, Power loss during learning cycle, Faulty limit switch or sensor not fully triggered
How to Fix / Troubleshooting
Safety first: Keep people and vehicles clear while re‑programming travel.
- Reset travel limits: Follow the Cardale manual to erase existing limits (often by holding SET/PROG) and then run a full open and close learning cycle.
- Check limit triggers: On models with physical limit switches, ensure the cams or magnets on the rail are correctly positioned and securely fastened.
- Verify unobstructed travel: Make sure the door can move fully open and closed manually before re‑learning.
Advertisements
Repair Difficulty
Easy
2/5
Required Part
Cardale Limit Switches / Travel Sensors
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements