COdE
MAAX Spas
General Control System Error
Display shows CODE or ERR; spa does not operate normally.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Firmware glitch, Corrupted control board memory, Incompatible topside control, Power surge damage to MAAX control pack
How to Fix / Troubleshooting
Safety: Disconnect power before opening the control pack.
- Hard reset: Turn off power at the breaker for at least 5 minutes, then restore. Observe if the error clears.
- Check topside cable: Inspect the cable between the topside control panel and the control pack for damage or loose connections.
- Inspect board: Look for burn marks, swollen components, or water damage inside the MAAX control pack.
- Verify compatibility: If a topside or board was recently replaced, confirm that the part numbers are compatible for your MAAX spa model.
- Board replacement: If the error persists and all peripherals test good, the control board may need replacement by a qualified technician.
Advertisements
Repair Difficulty
Professional Required
5/5
Advertisements