Frigidaire
Short Cycling / Overheat or Protection Trip
Dehumidifier runs briefly then shuts off; may restart after a few minutes and repeat the cycle.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Overheating compressor, Blocked condenser airflow, Faulty overload protector, Defective control board temperature sensing
How to Fix / Troubleshooting
Safety: Unplug before cleaning or opening panels.
Steps:
- Clean airflow path: Remove and clean the air filter. Vacuum the condenser coil and intake/exhaust grilles.
- Check placement: Ensure at least 12 inches of clearance around the unit and do not place it in a confined closet or cabinet.
- Monitor operation: Run the unit and feel the air discharge. It should be warm. If the compressor becomes extremely hot to the touch and shuts off, the overload may be tripping.
- Inspect compressor area: With power disconnected, inspect the overload protector and wiring for burn marks.
- Room conditions: Extremely high ambient temperatures can cause short cycling. Move the unit to a cooler area if possible.
- Service: Persistent short cycling may indicate a failing compressor or control board and should be evaluated by a technician.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Compressor Overload Protector
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements