E7 error code; unit may beep and stop; fan may run but compressor does not stay on long enough to make ice.

Safety first: Unplug before cleaning or moving the unit.

Improve environment:

• Move the AGLUCKY ice maker to a cooler room (ideally 50–90°F / 10–32°C).
• Ensure at least 6 inches (15 cm) clearance on all sides and above. Do not place it under low cabinets or next to ovens or dishwashers.

Clean cooling system:

• Remove the rear/side panel and vacuum or brush dust from the condenser coil and fan blades.
• Verify the condenser fan spins freely and starts whenever the compressor runs.

Reset and test:

• Allow the unit to cool for 30–60 minutes unplugged.
• Plug back in and start a cycle. If E7 reappears quickly in a cool, well-ventilated area, the temperature sensing or control board may be faulty and require replacement.