Ice maker starts a cycle but stops after a few minutes without producing ice; then restarts and repeats.
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Possible Causes
How to Fix / Troubleshooting
Safety first: Unplug before cleaning or moving the unit.
Improve operating conditions:
- Ensure adequate clearance around the unit and move it away from heat sources.
- Clean the condenser coil and fan to improve cooling efficiency.
Observe cycle behavior:
- After cleaning, run the unit and watch whether the evaporator gets cold and begins to frost before the cycle stops.
- If it stops while still warm, suspect a sensor or control issue.
Inspect sensors:
- Check the evaporator temperature sensor and wiring for secure attachment and damage.
If short cycling continues after these steps, a failing compressor or control board is likely and may require professional service.
Repair Difficulty
Required Part
We may earn a commission from links on this page.