Amica
Electrical Overheating / Component Failure
Ice maker emits a burning smell or shows signs of overheating around the rear panel.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Overheating compressor, Shorted wiring, Failing fan motor, Dust buildup on hot components
How to Fix / Troubleshooting
Safety first: Immediately unplug the ice maker and do not operate it until the cause is identified. Risk of fire.
- Inspect rear compartment: After cooling, remove the rear panel and look for burnt wires, melted insulation, or scorched PCB areas.
- Check fan and compressor: Ensure the fan spins freely and the compressor is not excessively hot to the touch after short operation.
- Clean dust: Remove dust from all components to improve cooling.
- Replace damaged parts: Any burned wiring, connectors, or motors must be replaced. If the PCB is burnt, replace the entire board.
- Seek professional service: If you cannot clearly identify and correct the source, contact an authorized Amica service center before using the appliance again.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Wiring Harness / Main Control PCB
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements