E10 error appears, ice cubes are irregular in size or the harvest cycle fails.

Safety: Disconnect power before adjusting or cleaning sensors.

• Locate the thickness sensor: On many Baridi ice makers, a metal or plastic probe sits near the evaporator to detect ice thickness before harvest.
• Clean the probe: Mineral deposits can insulate the probe. Wipe it with a cloth soaked in white vinegar, then rinse with clean water and dry.
• Check alignment and gap: Ensure the probe is positioned according to the user manual (typically a few millimeters from the evaporator surface). Gently bend or adjust the bracket if it has been knocked out of place.
• Inspect the switch or sensor body: Make sure the sensor housing is not cracked and that its wiring is intact. Reseat the connector on the control PCB.
• Test operation: After cleaning and adjustment, run a cycle and observe whether the machine now harvests at the correct ice thickness. If E10 returns, replace the ice thickness sensor assembly.