E13
Camry
Evaporator Over‑Ice / Freeze Protection Fault
E13 error, unit may freeze up with thick ice on the evaporator or stop mid‑cycle.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Faulty evaporator defrost sensor, Stuck ice thickness probe, Control board timing error, Poor water flow causing uneven freezing
How to Fix / Troubleshooting
Safety first: Unplug the ice maker. Allow heavy ice buildup to melt naturally; do not chip with sharp tools.
- Defrost the unit: Leave the cover open and place towels to catch meltwater. Once ice has melted, dry the interior.
- Inspect sensors: Check the evaporator sensor and ice thickness probe for correct mounting and clean off any scale.
- Verify water flow: Ensure the circulation pump and spray bar are clean and functioning so ice forms evenly.
- Reset control: After defrosting and cleaning, plug in and run a test cycle. Monitor ice thickness; if it grows excessively before harvest, the sensor or control board may be faulty.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Evaporator Defrost Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements