E19
Electrolux
Freeze Protection or Inlet Water Temperature Fault
Electrolux ice maker displays E19; ice production is disabled due to detected low water temperature or freeze protection.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Inlet water too cold, Faulty inlet water temperature sensor, Misreading cabinet thermistor, Control board logic fault
How to Fix / Troubleshooting
Safety First: Disconnect power before accessing sensors or control boards.
- Check installation: Ensure the water supply is not from a line that can freeze or drop below Electrolux's minimum inlet temperature.
- Inspect inlet sensor: If equipped, locate the inlet water temperature sensor near the fill tube or valve. Check wiring and mounting.
- Test sensor: Measure resistance at known temperatures and compare to specifications. Replace if out of range.
- Verify cabinet thermistor: If the unit is installed in a very cold environment (e.g., unheated garage), move it to a location within the specified ambient range.
- Reset and monitor: After correcting conditions and/or replacing sensors, clear the error and monitor several cycles.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Inlet Water Temperature Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements