Euhomy ice maker shows E10 and beeps; unit may shut down shortly after starting.

Safety first: Unplug the unit and be prepared for water spillage when disconnecting hoses.

Steps:

• 1. Check drain hose: For models with a drain connection, inspect the external hose for kinks, clogs, or elevation above the unit that could prevent proper draining. Straighten or clear as needed.
• 2. Inspect internal drain: Remove the rear or bottom panel to locate the internal drain tube and any drain pump. Check for blockages from scale, ice, or debris. Flush with warm water.
• 3. Clean drain sensor: Some models use a small float or sensor in the drain area. Clean it with warm water and a soft brush to remove slime or mineral buildup.
• 4. Verify sensor wiring: Ensure the drain sensor connector is firmly attached to the main control board and wires are intact.
• 5. Test operation: Reassemble, fill, and run the unit. If E10 persists and water is not draining properly, the drain sensor or pump may need replacement.