E14
Indesit
EEPROM / Configuration Data Error
E14 displayed; unit may beep continuously; internal memory or settings appear lost after power cycles.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted EEPROM on main control board, Power surge damage, Incorrect firmware version, Failed main control board
How to Fix / Troubleshooting
Safety: Unplug the appliance before removing the control board.
- Power reset: Disconnect the ice maker from mains for at least 10 minutes to allow capacitors to discharge. Reconnect and see if E14 clears.
- Check supply stability: Ensure the unit is not connected through a faulty extension lead or unstable power source. Use a surge protector if necessary.
- Service mode reset: Some Indesit models allow a factory reset via a button combination. Refer to the service manual and perform a configuration reset if available.
- Replace main control board: If E14 persists, the EEPROM or firmware on the main board is likely corrupted. Replace the main control board with the correct Indesit spare part.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements