Indesit Ice Makers Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E01
Ice maker will not power on, no lights on display, unit appears completely dead.
Main Control Board Power Supply Fault
E02
Ice maker powers on but does not start ice production; display shows E02 shortly after startup.
Water Inlet Valve / Fill Circuit Fault
E03
Ice maker stops mid-cycle and displays E03; ice bin is empty or only partially filled.
Water Level Sensor / Float Switch Error
E04
Display shows E04 and the unit stops; ice tray does not fill or overfills intermittently.
Ice Tray Fill Time-Out / Overfill Protection Fault
E05
Ice maker displays E05 and stops; compressor does not start or stops shortly after starting.
Compressor Start / Overload Protection Fault
E06
E06 displayed; ice production stops; fan noise may be absent or intermittent.
Condenser / Evaporator Fan Motor Fault
E07
E07 error appears; ice cubes are very small, hollow, or production is slow; unit may run continuously.
Low Refrigerant / Evaporator Temperature Fault
E08
E08 displayed; ice maker stops and may beep; internal temperature appears too high.
High Compartment Temperature / Overheat Fault
E09
E09 error; ice maker stops; water remains in reservoir and no ice is ejected.
Ice Harvest / Ejector Motor Fault
E10
E10 displayed; water leaks into ice bin or onto floor during operation.
Drain Pump / Drainage Fault
E11
E11 error; display may show a sensor icon; unit stops or runs erratically.
Ambient Temperature Sensor Fault
E12
E12 displayed; keypad or touch buttons do not respond or respond randomly.
User Interface / Keypad Communication Fault
E13
E13 error; ice bin is full but the unit continues to attempt production or stops unexpectedly.
Ice Bin Full Sensor / Infrared Beam Fault
E14
E14 displayed; unit may beep continuously; internal memory or settings appear lost after power cycles.
EEPROM / Configuration Data Error
E15
E15 error; audible alarm; water detected in base tray or anti-flood device activated.
Leak Detection / Anti-Flood Fault
E16
E16 displayed; unit runs but produces no ice; display may show a sensor icon related to ice thickness.
Ice Thickness Sensor / Probe Fault
E17
E17 error; unit may start then immediately stop; internal fan and compressor may not run.
Door / Access Panel Switch Fault
E18
E18 displayed; unit beeps and stops; internal self-test fails at startup.
General Hardware Self-Test Failure
Symptom
Buttons on the control panel are hard to press or stick, causing erratic operation.
Mechanical Keypad Wear
Symptom
Condensation or water droplets forming on the outside of the cabinet or around the door frame.
External Condensation
Symptom
Display is blank or very dim, but the compressor and fans still run.
Display / UI Power Fault
Symptom
Excessive frost or ice buildup on the evaporator or around the ice-making area.
Frost Accumulation / Defrost Imbalance
Symptom
Ice cubes appear cloudy or white instead of clear.
Air and Mineral Entrapment in Ice
Symptom
Ice cubes are fused together in large clumps inside the bin.
Ice Clumping in Storage Bin
Symptom
Ice cubes are too small, hollow, or melt quickly in the bin.
Improper Ice Cube Formation
Symptom
Ice cubes have a bad taste or odor, even though they appear clear.
Contaminated Water Path
Symptom
Ice maker does not produce any ice at all, but powers on and appears to run normally (no error code).
No Ice Production Without Error Indication
Symptom
Ice maker emits a burning smell or electrical odor during operation.
Overheating Electrical Component
Symptom
Ice maker interior light does not turn on when the door is opened.
Interior Light Failure
Symptom
Ice maker is running but makes a loud humming or buzzing noise.
Excessive Operational Noise
Symptom
Ice maker produces ice very slowly; ice bin never fills to capacity.
Reduced Ice Production Capacity
Symptom
Ice maker runs continuously without stopping, even when the ice bin is full.
Ice Level Detection Failure
Symptom
Ice maker starts then shuts off after a few minutes without producing ice, no error code shown.
Premature Cycle Termination
Symptom
Ice maker trips the household circuit breaker or RCD when it starts.
Electrical Short or Earth Leakage
Symptom
Ice maker vibrates excessively or moves on the floor during operation.
Excessive Vibration
Symptom
Ice maker will not start at all; display is on but no cycle begins when pressing start.
Start Inhibit / Control Lock Condition
Symptom
Rattling or clunking noise during ice harvest when cubes are released.
Mechanical Harvest Noise
Symptom
Water leaking from the front of the ice maker, pooling under the door or around the base.
Front Leak / Drainage Misrouting
Symptom
Water leaking from the rear of the ice maker near the inlet or drain connections.
Rear Plumbing Leak
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E01 |
Ice maker will not power on, no lights on display, unit appears completely dead.
|
Main Control Board Power Supply Fault | View Details |
| E02 |
Ice maker powers on but does not start ice production; display shows E02 shortly after startup.
|
Water Inlet Valve / Fill Circuit Fault | View Details |
| E03 |
Ice maker stops mid-cycle and displays E03; ice bin is empty or only partially filled.
|
Water Level Sensor / Float Switch Error | View Details |
| E04 |
Display shows E04 and the unit stops; ice tray does not fill or overfills intermittently.
|
Ice Tray Fill Time-Out / Overfill Protection Fault | View Details |
| E05 |
Ice maker displays E05 and stops; compressor does not start or stops shortly after starting.
|
Compressor Start / Overload Protection Fault | View Details |
| E06 |
E06 displayed; ice production stops; fan noise may be absent or intermittent.
|
Condenser / Evaporator Fan Motor Fault | View Details |
| E07 |
E07 error appears; ice cubes are very small, hollow, or production is slow; unit may run continuously.
|
Low Refrigerant / Evaporator Temperature Fault | View Details |
| E08 |
E08 displayed; ice maker stops and may beep; internal temperature appears too high.
|
High Compartment Temperature / Overheat Fault | View Details |
| E09 |
E09 error; ice maker stops; water remains in reservoir and no ice is ejected.
|
Ice Harvest / Ejector Motor Fault | View Details |
| E10 |
E10 displayed; water leaks into ice bin or onto floor during operation.
|
Drain Pump / Drainage Fault | View Details |
| E11 |
E11 error; display may show a sensor icon; unit stops or runs erratically.
|
Ambient Temperature Sensor Fault | View Details |
| E12 |
E12 displayed; keypad or touch buttons do not respond or respond randomly.
|
User Interface / Keypad Communication Fault | View Details |
| E13 |
E13 error; ice bin is full but the unit continues to attempt production or stops unexpectedly.
|
Ice Bin Full Sensor / Infrared Beam Fault | View Details |
| E14 |
E14 displayed; unit may beep continuously; internal memory or settings appear lost after power cycles.
|
EEPROM / Configuration Data Error | View Details |
| E15 |
E15 error; audible alarm; water detected in base tray or anti-flood device activated.
|
Leak Detection / Anti-Flood Fault | View Details |
| E16 |
E16 displayed; unit runs but produces no ice; display may show a sensor icon related to ice thickness.
|
Ice Thickness Sensor / Probe Fault | View Details |
| E17 |
E17 error; unit may start then immediately stop; internal fan and compressor may not run.
|
Door / Access Panel Switch Fault | View Details |
| E18 |
E18 displayed; unit beeps and stops; internal self-test fails at startup.
|
General Hardware Self-Test Failure | View Details |
| – |
Buttons on the control panel are hard to press or stick, causing erratic operation.
|
Mechanical Keypad Wear | View Details |
| – |
Condensation or water droplets forming on the outside of the cabinet or around the door frame.
|
External Condensation | View Details |
| – |
Display is blank or very dim, but the compressor and fans still run.
|
Display / UI Power Fault | View Details |
| – |
Excessive frost or ice buildup on the evaporator or around the ice-making area.
|
Frost Accumulation / Defrost Imbalance | View Details |
| – |
Ice cubes appear cloudy or white instead of clear.
|
Air and Mineral Entrapment in Ice | View Details |
| – |
Ice cubes are fused together in large clumps inside the bin.
|
Ice Clumping in Storage Bin | View Details |
| – |
Ice cubes are too small, hollow, or melt quickly in the bin.
|
Improper Ice Cube Formation | View Details |
| – |
Ice cubes have a bad taste or odor, even though they appear clear.
|
Contaminated Water Path | View Details |
| – |
Ice maker does not produce any ice at all, but powers on and appears to run normally (no error code).
|
No Ice Production Without Error Indication | View Details |
| – |
Ice maker emits a burning smell or electrical odor during operation.
|
Overheating Electrical Component | View Details |
| – |
Ice maker interior light does not turn on when the door is opened.
|
Interior Light Failure | View Details |
| – |
Ice maker is running but makes a loud humming or buzzing noise.
|
Excessive Operational Noise | View Details |
| – |
Ice maker produces ice very slowly; ice bin never fills to capacity.
|
Reduced Ice Production Capacity | View Details |
| – |
Ice maker runs continuously without stopping, even when the ice bin is full.
|
Ice Level Detection Failure | View Details |
| – |
Ice maker starts then shuts off after a few minutes without producing ice, no error code shown.
|
Premature Cycle Termination | View Details |
| – |
Ice maker trips the household circuit breaker or RCD when it starts.
|
Electrical Short or Earth Leakage | View Details |
| – |
Ice maker vibrates excessively or moves on the floor during operation.
|
Excessive Vibration | View Details |
| – |
Ice maker will not start at all; display is on but no cycle begins when pressing start.
|
Start Inhibit / Control Lock Condition | View Details |
| – |
Rattling or clunking noise during ice harvest when cubes are released.
|
Mechanical Harvest Noise | View Details |
| – |
Water leaking from the front of the ice maker, pooling under the door or around the base.
|
Front Leak / Drainage Misrouting | View Details |
| – |
Water leaking from the rear of the ice maker near the inlet or drain connections.
|
Rear Plumbing Leak | View Details |
No matching codes found
Advertisements