Kenmore
Premature Shutdown – Overheat or Fault Detection
Kenmore ice maker starts a cycle but shuts off prematurely before ice is formed.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Overheating compressor due to dirty condenser, Faulty temperature sensor, Weak compressor start components, Control board misreading sensors
How to Fix / Troubleshooting
Safety First: Disconnect power before cleaning or accessing internal components.
- Clean condenser and verify fan: Dirty coils and a non-running fan can cause overheating and shutdown. Clean coils and ensure the fan runs.
- Check ambient temperature: Ensure the unit is not installed in a very hot space above the rated temperature.
- Inspect sensors: Check evaporator and cabinet thermistors for secure mounting and intact wiring. Replace if readings are erratic.
- Monitor operation: After cleaning and checks, run the unit and observe. If it still shuts down early, professional diagnosis of compressor and control board may be needed.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Evaporator Thermistor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements