ProfiCook Intermittent Control or Sensor Fault

Ice maker produces ice only for a short time, then stops until manually restarted.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Over-sensitive ice-full sensor, Overheating control board, Loose internal connector, Software glitch

Safety first: Unplug the ProfiCook ice maker before inspecting internal connections.

Clean sensors: Wipe the ice-full and temperature sensor areas to remove frost and dirt.
Improve ventilation: Ensure the control board area (usually near the side or top) is not blocked by objects or heat sources.
Power reset: Unplug for 10 minutes to reset the control electronics.
If behavior persists: A loose connector or failing control PCB may be the cause and should be checked by a technician.

Hard 4/5

Main Control PCB / Ice Full Sensor

Check Price on Amazon

We may earn a commission from links on this page.