Russell Hobbs
General Control Fault or Overload Protection
Ice maker stops mid-cycle and all lights flash
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Control PCB firmware error, Overheating of compressor or PCB, Voltage fluctuation, Internal short in motor or pump
How to Fix / Troubleshooting
Safety: Unplug the unit before further investigation.
Steps:
- Power cycle: Leave the unit unplugged for 15–20 minutes to allow any thermal protectors to reset and the control to fully power down.
- Improve cooling: Ensure good ventilation around the unit and clean the condenser and fan.
- Check for blocked mechanisms: Inspect the ice shovel and tray for jams that could overload motors.
- Test again: Plug back in and run a cycle. If the fault repeats quickly, the main control PCB or a connected motor may be failing and should be tested and replaced by a technician.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control PCB
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements