Sencor
Premature cycle termination
Ice maker starts a cycle but stops after a few minutes without producing ice; no error code displayed.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Overheating due to blocked vents, Faulty thermostat or temperature sensor, Intermittent main control board fault, Unstable power supply
How to Fix / Troubleshooting
Safety: Disconnect power before cleaning or opening the unit.
Steps:
- Improve ventilation: Ensure at least 10–15 cm clearance around the unit and that vents are not blocked by walls or other appliances.
- Clean condenser: Dust off the condenser coil and fan area to improve cooling.
- Check power source: Avoid using long or thin extension cords. Plug directly into a grounded wall outlet.
- Sensor check: If the problem persists, the evaporator temperature sensor or main control board may be intermittently failing and should be tested or replaced by a technician.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Evaporator Temperature Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements