Sencor Overheating electrical component

Unit emits a burning smell during operation.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Burning fan or pump motor windings, Overheated compressor start relay, Shorted component on main PCB, Melted wiring insulation

Safety: Immediately unplug the ice maker and do not continue using it until inspected.

Inspection:

Visual check: Open the rear/bottom panel and look for scorched components, melted plastic, or discolored wiring.
Identify source: Smell near the compressor, fan, pump, and PCB to locate the strongest odor (only when unplugged and cooled).
Replace damaged parts: Replace any burnt fan motor, water pump, compressor start relay, or main control board. Damaged wiring should be repaired by a qualified technician.

Professional Required 5/5

Main Control Board

Check Price on Amazon

We may earn a commission from links on this page.