Ice maker displays E09 and stops, compressor runs briefly then shuts off
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Possible Causes
How to Fix / Troubleshooting
Safety: Unplug the unit before cleaning the condenser or fan. Wear gloves and a dust mask if sensitive.
Cooling system maintenance:
- Check installation clearance: Ensure the Siemens ice maker has the required ventilation space around the sides, back, and top as specified in the manual.
- Clean condenser: Remove the lower rear panel and use a soft brush and vacuum to remove dust from the condenser coils. Avoid bending the fins.
- Inspect condenser fan: Verify the fan blades are clean and can spin freely. If the motor is noisy, seized, or does not run when the compressor is on, replace the condenser fan motor.
- Ambient temperature: If the unit is installed in a very hot room or near heat sources, relocate it or improve ventilation.
Reset: After cleaning and ensuring proper airflow, disconnect power for 5 minutes, then restore power and monitor operation.
Repair Difficulty
Required Part
We may earn a commission from links on this page.