How to Fix / Troubleshooting

Safety: Turn off water and disconnect power before servicing the water circuit.

Flow sensor checks:

Bleed air: Turn off the unit, then slowly open the water supply to purge air. Restart and observe if the error returns.
Locate flow meter: On many Siemens models, the flow meter is installed in-line between the inlet valve and reservoir. Remove the cover to access it.
Inspect for debris: Disconnect the hoses and check the internal wheel or turbine for scale or debris. Rinse gently with clean water.
Check wiring: Ensure the flow meter connector is secure and wires are not damaged.
Replace flow meter: If the sensor does not register flow despite good water supply, replace the flow meter with a Siemens-approved part.

E17 error, ice maker stops, water-related fault indicated

Possible Causes