Siemens Overfilling of Ice Tray

Ice cubes are too large, overflowing the tray and sticking together

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Sticking inlet valve, Incorrect fill time setting, Faulty water level sensor, High water pressure

Safety: Disconnect power and close water supply before inspection.

Correcting overfill:

Observe fill: Manually start a cycle and watch the fill. If water continues after the valve should close, replace the inlet valve.
Check pressure: Install or verify a pressure regulator if household pressure is very high.
Inspect level sensor: Clean and test the Siemens water level sensor or float. Replace if it does not respond correctly.

Medium 3/5

Water Level Sensor / Inlet Valve

Check Price on Amazon

We may earn a commission from links on this page.