E5 error on display; compressor may not start or may shut down quickly; unit stops making ice.

Safety: Unplug the ice maker. The compressor and condenser can be hot; allow them to cool before touching.

Steps to address E5:

• 1. Improve ventilation: Ensure the Vremi ice maker has at least 6 inches (15 cm) of clearance on all sides and is not placed in a confined cabinet. Move it away from heat sources.
• 2. Clean condenser coils: Remove the rear cover to access the condenser. Use a soft brush or vacuum to remove dust and lint from the coils and fan guard.
• 3. Check condenser fan: Spin the fan blade by hand (with power disconnected). It should move freely. If stiff or seized, the condenser fan motor may need replacement.
• 4. Inspect overload protector: The compressor overload/thermal protector is usually clipped to the side of the compressor. Check for signs of burning or melting. Reseat the connector.
• 5. Test fan operation: Reassemble, plug in, and start a cycle. Confirm the fan runs whenever the compressor is on. If the fan does not run, test and replace the fan motor.
• 6. Replace overload (advanced): If the compressor is cool but E5 persists and the overload is suspected, replace the compressor overload protector with a compatible part.

Important: If the compressor is extremely hot, cycles on and off rapidly, or hums without starting, there may be a sealed-system or compressor failure. This requires a professional with refrigeration certification.