Vremi
Control Logic Instability / Sensor Misread
Unit cycles on and off rapidly without completing a full ice-making cycle.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Loose sensor connections, Faulty temperature sensor, Corrupted control board firmware, Intermittent power supply
How to Fix / Troubleshooting
Safety: Unplug the unit before reseating connectors.
Steps:
- 1. Power reset: Leave the unit unplugged for 30 minutes to fully reset the control.
- 2. Reseat connectors: Access the main control board and gently unplug/replug all sensor connectors (ambient, evaporator, water level, ice full).
- 3. Inspect for damage: Look for corroded pins or moisture on the board. Dry and clean as needed.
- 4. Replace suspect sensor: If cycling corresponds to temperature changes, replace the evaporator NTC sensor or ambient NTC sensor as appropriate.
Action: If instability persists, the main control board may need replacement.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Evaporator NTC Temperature Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements