Unit frequently shows 'Add Water' or stops due to low water even when the reservoir is full (no specific code).

Safety: Unplug the ice maker and remove the reservoir.

Steps:

• 1. Clean float mechanism: Locate the float or magnetic float tube near the pump intake. Clean thoroughly with warm water and vinegar to remove scale.
• 2. Verify free movement: Move the float up and down; it should move smoothly and return freely.
• 3. Check magnet alignment: Ensure the float magnet passes directly by the reed switch location. Adjust if the float has shifted.
• 4. Replace sensor: If the problem persists, replace the Vremi water level float switch assembly.

Tip: Avoid using very hard water, which accelerates mineral buildup on sensors.