E19
Vida Display / VFD or LED Driver Fault

Microwave displays E19 and the clock or display is blank or partially lit.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Failed display module, Faulty display driver on control PCB, Loose display ribbon cable, Power surge damage to display circuit

How to Fix / Troubleshooting

Safety: Unplug the microwave before removing the control panel.

Steps:

  • 1. Power reset: Unplug for 5 minutes and plug back in.
  • 2. Panel access (for DIYers): Remove the control panel and inspect the ribbon cable between the display and control board. Reseat the connector.
  • 3. Visual inspection: Look for darkened or cracked display glass or burned components near the display driver.

If the display remains blank or E19 persists, the display module or main control PCB will need replacement. This is a low-voltage repair but requires careful handling of connectors.

Advertisements

Repair Difficulty

Medium 3/5

Required Part

Display Module
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements