Binatone Premature Program Termination / False Temperature Reached

Multicooker switches to KEEP WARM too early, before food is fully cooked.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Loose or mispositioned NTC sensor, Poor contact between pot and heating plate, Firmware miscalculation on PCB, Excessive scaling or residue on pot bottom

How to Fix / Troubleshooting

Safety first: Unplug the cooker before internal inspection.

  • Clean contact surfaces: Thoroughly clean the inner pot bottom and heating plate to remove any buildup.
  • Check pot type: Use only the original Binatone inner pot. Third‑party pots may not conduct heat correctly.
  • Reset cooker: Perform a full power reset by unplugging for 10 minutes, then retry the program.
  • Sensor inspection (technician): Verify that the NTC sensor is firmly attached to the heating plate and has not shifted. Reseat or replace as needed.
  • PCB replacement: If the issue persists across multiple recipes, the control PCB may be miscalculating cook completion and should be replaced.
Advertisements

Repair Difficulty

Medium 3/5

Required Part

Bottom NTC Temperature Sensor Assembly
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements