P0
Eldom
Power Supply / Low Voltage Protection
Display shows P0 and the cooker does not heat; some buttons may still respond.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Input voltage below specification, Internal power supply fault on main PCB, Loose mains cord connection, Damaged power filter components
How to Fix / Troubleshooting
Safety: Always unplug before inspecting the power cord or opening the housing.
- Check outlet: Test the wall outlet with another high-power appliance. Avoid using long extension cords or multi-socket adapters.
- Inspect power cord: Examine the Eldom power cord for cuts, kinks, or burn marks. Replace if damaged.
- Check cord connection: On models with a detachable cord, ensure it is fully inserted into the cooker socket.
- Internal inspection (advanced): Remove the bottom cover and inspect the input power terminals and filter board for loose screws or burnt components.
If P0 persists with a known-good outlet and cord, the internal power supply section of the main control PCB is likely faulty and should be replaced.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control PCB (Power Supply Section)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements