E11
Electrolux
Real-Time Clock / Timer Circuit Fault
E11 error appears when trying to start a program that uses delayed start or timer functions.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted firmware, Failed RTC chip on control board, Power surge damage, Loose control board connectors
How to Fix / Troubleshooting
Safety first: Disconnect power before opening the unit.
- Factory reset (if supported): Consult the Electrolux user manual for a reset procedure (often holding specific buttons while plugging in). Perform the reset and re-test.
- Avoid delayed start: If normal immediate-cook programs work, avoid using delayed start until the board is repaired.
- Check power quality: Use a surge protector to prevent further damage from voltage spikes.
- Internal check (advanced): Inspect the main PCB for obvious burn marks or swollen components. Reseat all connectors.
- If E11 continues, the main control PCB (RTC section) is likely faulty and must be replaced as a complete module.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control PCB
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements