E19
Salter
Display Module / LED Driver Fault
Salter oven displays E19 and the display is dim or partially missing segments.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed LED/LCD display module, Dry joints on display connector, Faulty display driver IC on PCB, Low voltage supply to display
How to Fix / Troubleshooting
Safety first: Isolate the oven from mains power before removing the control panel.
- Check connections: Remove the control panel and reseat the display connector or ribbon cable. Inspect for corrosion or loose pins.
- Inspect solder joints: Examine the display and driver IC solder joints with a magnifier. Reflow any cracked joints if you are competent with soldering, or replace the board.
- Measure low‑voltage supply: If you have the skills and tools, verify that the display is receiving the correct DC voltage from the control PCB. If not, the PCB power supply section may be faulty.
- Replace display or PCB: If the display itself is dim or missing segments despite correct supply and connections, replace the display module or the entire control PCB, depending on how Salter supplies the part.
Warning: Incorrect handling of the PCB can cause electrostatic damage. Use ESD precautions where possible.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Display Module / Control PCB
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements