E17
Tower
Door Unlock Timeout / Position Error
Oven displays E17 and the door will not unlock after a self-clean or high-temperature cycle.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Door lock motor not returning to open position, Warped door latch from heat, Faulty door lock position switch, Control board not detecting unlock signal
How to Fix / Troubleshooting
Safety first: Allow the oven to cool completely. Turn off power before attempting mechanical adjustments.
Steps to check:
- Cooling: Wait at least 30–60 minutes after a self-clean cycle; the lock will not release until the temperature sensor reads safe.
- Power reset: Turn off power for 5 minutes, then restore and see if the lock cycles.
- Manual release: On some Tower models, a manual release lever is accessible through the top or front panel. Consult the service documentation if available.
- Inspect lock: If accessible, check the lock motor and linkage for binding or heat damage. Replace the door lock assembly if it does not move freely.
Warning: Do not force the door open with tools; this can shatter the glass and damage the cabinet.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Door Lock Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements