Er10
Outdoorchef
Pellet Feed Calibration / Auger Control Error
Display shows Er10; grill cannot maintain low temperatures and cycles erratically.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect feed rate calibration, Faulty auger speed control on board, Intermittent auger motor, Software glitch in controller
How to Fix / Troubleshooting
Safety first: Turn OFF and unplug the grill before working on wiring.
- Reset controller: Perform a factory reset or feed calibration procedure as described in the Outdoorchef manual for your model.
- Observe auger operation: Start the grill and watch the auger cycles. It should run in consistent on/off intervals. Long continuous runs at low setpoints indicate a control issue.
- Check auger motor: Listen for irregular noises or stalling. Intermittent operation can confuse the controller and trigger Er10.
- Firmware update: If your model supports firmware updates (via USB or app), ensure the controller is on the latest version.
If calibration and firmware updates do not resolve Er10, the main control board's auger control circuit may be faulty and require replacement.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements