E09
Espa
Internal Electronics Fault / Control PCB Error
Espa pump controller shows E09 and refuses to start after a power surge
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Damaged control PCB from voltage spike, Corrupted firmware, Shorted component on drive board
How to Fix / Troubleshooting
Safety first: Disconnect power before opening the control housing.
- 1. Power cycle: Turn off the breaker for at least 5 minutes to fully discharge internal capacitors. Restore power and attempt to restart the pump.
- 2. Inspect for visible damage: If accessible, open the Espa control box and look for burnt components, scorch marks, or a burnt smell on the PCB. Do not touch components with power applied.
- 3. Check surge protection: Verify that any external surge protector or line filter is intact. If a surge event occurred, consider installing or upgrading surge protection for the pump circuit.
- 4. Reset to factory settings: If the user manual provides a key sequence to reset the controller, perform a factory reset. This may clear firmware-related E09 errors.
If E09 persists, the control PCB or entire drive module will likely need replacement by an authorized Espa service technician.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Espa control PCB / drive module
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements