E06
Jacuzzi Motor Speed Feedback / Hall Sensor Error

Pump display shows E06 and motor speed fluctuates or will not reach set RPM.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Loose feedback connector between motor and drive, Damaged speed sensor in motor, Faulty control board input circuit, Water ingress at motor terminal housing

How to Fix / Troubleshooting

Safety first: Turn off power at the breaker before removing any covers.

Steps to check:

  • Inspect motor harness: Locate the low-voltage feedback cable between the Jacuzzi motor and drive module. Ensure the plug is fully seated and free of corrosion.
  • Check for water intrusion: Open the motor terminal housing and look for signs of moisture or rust on connectors.
  • Secure strain relief: Make sure the cable strain relief is tight so vibration does not loosen the connector.
  • Test at different speeds: After reassembly, run the pump at a low and then high RPM. If E06 appears at all speeds, the sensor or drive is likely defective.

Speed feedback faults usually require replacement of the motor assembly (with integrated sensor) or the drive module, depending on which component is confirmed faulty.

Advertisements

Repair Difficulty

Hard 4/5

Required Part

Jacuzzi pump motor assembly
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements