F1
Blomberg Electronic Oven Control Internal Failure

Range or built-in oven displays F1 and may beep continuously; oven may not respond to commands.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Electronic oven control (EOC) logic fault, Power surge damage, Internal relay or processor failure

How to Fix / Troubleshooting

Safety first: Turn off power at the breaker before removing any panels. High voltage is present inside the control area.

  • Power cycle: Turn the breaker off for 10 minutes, then back on. If F1 returns immediately, the EOC is likely faulty.
  • Inspect wiring: Remove the rear console cover. Check for burnt connectors, loose harness plugs, or signs of moisture on the EOC board. Correct any loose connections.
  • Check for overheating: Look for discoloration on the board or melted plastic around relays. This indicates internal failure.
  • Replace EOC: If F1 persists after wiring checks and reset, replace the electronic oven control with the correct Blomberg part number for your model.

Due to the need to handle live-voltage components and correctly transfer wiring, this repair is best done by an experienced DIYer or technician.

Advertisements

Repair Difficulty

Hard 4/5

Required Part

Electronic Oven Control (EOC)
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements