Blomberg Ranges & Cooktops Error Codes

F0

Electronic oven control displays F0 and beeps; oven functions may be disabled or behave erratically.

Stuck or Shorted Oven Keypad

F1

Range or built-in oven displays F1 and may beep continuously; oven may not respond to commands.

Electronic Oven Control Internal Failure

F10

F10 appears and oven may shut off; sometimes accompanied by rapid temperature rise.

Runaway Oven Temperature / Sensor Out of Range

F11

F11 error with continuous beeping; oven may not respond to keypad inputs.

Key Stuck or Shorted on Touchpad

F12

F12 displayed; oven functions disabled or intermittent.

Communication Error Between Display and Power Board

F13

F13 error; oven may not start or may stop mid-cycle, especially on models with meat probe.

Meat Probe Circuit Fault (if equipped) or Auxiliary Sensor Error

F2

Oven shows F2 during or after a bake or broil cycle; oven may overheat or shut down.

Oven Over-Temperature Condition

F20

F20 error on induction cooktop; one or more zones do not heat.

Induction Coil Overheat or Temperature Sensor Fault

F21

F21 error on induction cooktop; affected zone will not heat.

Induction Coil or Power Module Fault

F22

F22 error on induction cooktop; cooktop may shut down or limit power.

Cooktop Overtemperature / Cooling System Fault

F23

F23 error on induction cooktop; one or more zones do not detect cookware properly.

Cookware Detection / Induction Sensor Fault

F24

F24 error on induction cooktop; entire cooktop may shut down.

Supply Voltage Out of Range

F25

F25 error on induction cooktop; touch controls may be unresponsive or erratic.

Touch Control Panel Fault

F3

Display shows F3 and oven will not heat or stops mid-cycle.

Oven Temperature Sensor Circuit Open

F30

F30 error on gas range; oven ignition fails and no flame is established.

Oven Ignition Failure

F31

F31 error on gas range; broil burner fails to ignite.

Broil Ignition Failure

F4

Display shows F4; oven may not heat correctly or may shut down.

Oven Temperature Sensor Circuit Shorted

F40

F40 error on electric range; one or more oven heating elements do not operate.

Oven Heating Element Circuit Fault

F5

F5 appears on the display; oven door may not lock or unlock during self-clean.

Oven Door Lock Circuit Fault

F50

F50 error on gas cooktop with electronic ignition; burners will not spark.

Ignition Spark Module Fault

F51

F51 error on gas cooktop; one burner does not spark while others do.

Single Burner Ignition Fault

F60

F60 error on dual-fuel or electric range; convection fan does not run.

Convection Fan Motor Fault

F7

Display shows F7; keypad may not respond correctly or random buttons appear to be pressed.

Keypad Matrix or Control Panel Short

F8

F8 error appears; cooling fan may run continuously or oven may not start.

Cooling Fan or Fan Feedback Fault

F9

F9 error displayed; oven door may not lock/unlock or self-clean will not start.

Door Latch Lock/Unlock Timeout

Symptom

Clock and timer work but oven will not start; display shows time only, no error.

Oven Not in Manual Mode / Child Lock or Timer Active

Symptom

Control knobs are hard to turn or feel stuck on gas cooktop.

Stiff Gas Valve Stem or Contaminated Knob

Symptom

Cooktop glass is cracked or shattered.

Ceramic Glass Surface Damage

Symptom

Electric cooktop radiant element cycles on and off too frequently or does not reach high temperature.

Temperature Limiter or Control Misregulation

Symptom

Electric cooktop radiant element does not heat at all.

Open Radiant Heating Element Circuit

Symptom

Gas cooktop burner clicks continuously even after flame is established.

Flame Sensing / Ignition Switch Stuck

Symptom

Gas cooktop burner flame is very low or goes out when turned to low setting.

Low Flame / Simmer Adjustment Issue

Symptom

Gas cooktop burner flame is yellow and produces soot on cookware.

Improper Air-Gas Mixture

Symptom

Gas cooktop burner will not ignite but can be lit with a match.

Igniter Electrode Contamination or Misalignment

Symptom

Induction cooktop shuts off unexpectedly during cooking without error code.

Thermal Protection or Power Management Shutdown

Symptom

Induction cooktop zone displays pan symbol but does not heat, no error code.

Cookware Compatibility or Pan Detection Issue

Symptom

Oven does not heat in bake mode but broil works.

Failed Bake Element or Bake Circuit

Symptom

Oven does not heat in broil mode but bake works.

Failed Broil Element or Broil Circuit

Symptom

Oven door will not close fully or appears misaligned.

Door Hinge or Hinge Receiver Deformation

Symptom

Oven door will not open after self-clean cycle completes (no error code).

Door Lock Mechanism Stuck

Symptom

Oven fan is noisy, rattling, or squealing during operation.

Worn or Obstructed Convection or Cooling Fan

Symptom

Oven light does not work but oven heats normally.

Oven Cavity Lamp Failure

Symptom

Oven produces excessive smoke and burning smell during normal baking.

Contamination or Spillage on Heating Elements

Symptom

Oven temperature is consistently too hot or too cold compared to set temperature.

Oven Temperature Calibration / Sensor Drift

Symptom

Range control panel is completely dead; no display or response.

No Power to Control / Main Power Failure

Symptom

Range trips the circuit breaker when oven or cooktop is turned on.

Short Circuit or Ground Fault

Symptom

Strong gas smell around range, especially when burners are off.

Gas Leak in Supply or Burner System