How to Fix / Troubleshooting

Safety first: Turn off power before checking wiring or boards.

Steps:

Verify wiring configuration: Compare the current terminal block wiring with the diagram on the hob label. Ensure phase, neutral, and bridges are correctly installed.
Power reset: Disconnect power for 10 minutes, then reconnect. Sometimes the control will reinitialize.
Check recent repairs: If a control board was recently replaced, it may require configuration or may be the wrong part number. Verify the part number against Brandt documentation.
Service mode (technician only): Some Brandt models allow entering a service mode to reset or calibrate the electronics. This should only be done with the official service manual.
Board replacement: If E10 persists and wiring is correct, the main control board is likely defective and must be replaced.

Induction hob displays E10 and beeps continuously when powered on.

Possible Causes