F10
Brandt
Overtemperature / Safety Cut-Out Fault
Brandt oven displays F10 and heating stops during operation.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blocked cooling vents, Failed cooling fan, Faulty overheat thermostat, Control board temperature monitoring fault
How to Fix / Troubleshooting
Safety first: Allow the oven to cool completely and disconnect power before inspection.
Steps:
- Check installation: Ensure the range has proper clearance around it and that vents are not blocked by cabinets or foil.
- Inspect cooling fan: Confirm that the fan runs during and after cooking. If not, test and replace the fan motor.
- Test safety thermostat: Locate the thermal cut-out on the top or rear of the oven cavity. Check for continuity; replace if open and non-resettable.
- Control board: If all hardware is good, the control board may be falsely detecting overtemperature and should be replaced.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Oven Overheat Thermostat
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements