E10
Candy
Configuration or Calibration Error
Induction cooktop shows E10 and locks out all zones
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect configuration after board replacement, Firmware mismatch between UI and power module, Corrupted EEPROM on control board
How to Fix / Troubleshooting
Safety first: Disconnect from mains before removing any covers.
- Power cycle: Turn off the breaker for 5 minutes to allow the electronics to fully discharge, then restore power and test.
- Check for recent repairs: If a control or power board was recently replaced, verify that the correct Candy spare part number was used and that any configuration jumpers or DIP switches are set according to the service manual.
- Factory reset (if available): Some Candy models allow a service reset via a key combination on the touch panel. Refer to the technical documentation or contact Candy support for the correct procedure.
- Board replacement: If E10 persists, the user interface PCB or main power module may have corrupted memory and require replacement.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements