Display shows F41, oven may not respond to commands.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed EOC, Faulty door lock motor feedback, Loose wiring to motorized damper or lock, Control firmware issue

Safety first: Turn off power before servicing.

Check motorized components: Inspect the door lock motor and any motorized dampers for proper connection and obvious damage.
Reseat connectors: Reseat all plugs between the EOC and these components.
Test components: Use a multimeter to verify that motors and switches have proper resistance and continuity.
Replace EOC: If all connected devices test good, the EOC is likely at fault and should be replaced.

Hard 4/5

Electronic Oven Control Board (EOC)

Check Price on Amazon

We may earn a commission from links on this page.