E07
Hoover
Induction Coil / IGBT Drive Fault
Induction hob displays E07 and one specific zone cannot be used.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Open or shorted induction coil, Failed IGBT transistor on zone power board, Burnt track on PCB, Loose coil connector
How to Fix / Troubleshooting
Safety first: Switch off the appliance at the mains. Internal components can retain charge; only qualified personnel should access the electronics.
- Test other zones: Confirm that other zones operate normally. If only one zone shows E07, the fault is localised to that coil or driver.
- Avoid using the faulty zone: Continued attempts may stress the power electronics further.
- Professional diagnosis: A Hoover technician should remove the hob, inspect the induction coil and zone power board for burn marks, and test continuity and insulation.
- Repair: Replace the defective coil or power module. Both parts are usually supplied as Hoover‑specific assemblies.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Induction Coil Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements