E10
Hoover
Configuration / EEPROM Error
Hob shows E10 and all zones are locked out.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted configuration memory on control board, Power surge damage, Incorrect replacement PCB not programmed for this model
How to Fix / Troubleshooting
Safety first: Turn off the appliance at the mains.
- Power reset: Leave the hob disconnected for at least 15 minutes to fully discharge internal circuits, then reconnect and test.
- Check for recent work: If a control board was recently replaced, it may require Hoover factory configuration or may be the wrong part number.
- Surge protection: If E10 appeared after a storm or power cut, consider having an electrician check your supply and install surge protection.
- Professional reprogramming: A Hoover technician may be able to reprogram or must replace the main control PCB with the correct pre‑configured part.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control PCB
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements