F4E1 error; oven may think a probe is inserted when it is not, or may not allow normal baking.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Shorted probe jack, moisture in probe connector, shorted probe cable, failed control probe input

Warning: Turn off power before servicing.

Check for debris: Inspect the probe jack inside the oven for food debris or moisture. Clean gently and allow to dry.
Inspect wiring: From the rear, check the probe jack harness for pinched or shorted wires.
Disconnect jack: Temporarily disconnect the probe jack harness from the control board. Restore power; if the error clears, replace the jack assembly.
Replace control: If the error persists with the jack disconnected, the control board probe circuit may be defective and require replacement.

Hard 4/5

Meat Probe Jack Assembly or Electronic Oven Control

Check Price on Amazon

We may earn a commission from links on this page.